News & Events
Alternative to Enameled Magnet Wire: Powder Coatings for Wire, Strips, & Stampings
There is a better alternative to enameled magnet wire. Magnet wire is used extensively in power systems for transformers and motors plus speakers, hard drives, and electromagnets – in fact anything that needs tight coils of insulated wire. "Enameled" magnet wire is...
read moreHow ADS-B Helps Operators See and Avoid Other Aircraft
ADS-B helps you see and avoid because “you can't avoid - what you can't see.” Whether you're on an IFR flight plan, VFR over-the-top, Flight Following or just heading out for that $100 hamburger; it is the pilot's primary responsibility to see and avoid other...
read moreInspect the EWIS While Installing ADS-B Equipment
During your ADS-B install, take the opportunity to inspect and protect the aircraft’s critical EWIS against chafe induced arc, spark, and combustion. Close inspection on the ground is warranted as forces created by flight can cause cable, harnesses and lines to shift...
read more
See DTi at the Northern California Design-2-Part Show May 22-23
DTi, in partnership with DB Roberts, will be attending the Northern California Design-2-Part Show May 22-23, 2019 at the Santa Clara Convention Center, Santa Clara, CA. Come visit us to see why UL94V-0 Rated and FAA Approved Spring-Fast® Grommet Edging is the best...
read moreCountdown to Compliance on the ADS-B Mandate
ADS-B Out must be installed and operating by 1/1/2020. In this post we’ll go through some common questions about the mandate and the possibility of date slippage The Facts FAA’s ADS-B (Automatic Dependent Surveillance-Broadcast) uses satellites, not radar, to fix...
read moreThe Upgrade Challenge for Racks and Chassis in Data Center Architecture
Sooner or later you will want to upgrade your network which will include the wiring and the multiple racks and chassis you have installed over time. One factor making this happen faster is 5G. 5G is opening up new business models with the convergence of wired and...
read more
See DTi at the Southeast Design-2-Part Show March 28-29
DTi, in partnership with DB Roberts, will be attending the Southeast Design-2-Part Show March 28-29, 2019 at the Cobb Galleria Centre in Atlanta, GA. Come visit us in Booth #102 to see why UL94V-0 Rated and FAA Approved Spring-Fast® Grommet Edging is the best choice...
read more
DTi to attend AmCon Advanced Design & Manufacturing Expo March 19-20
DTi, in partnership with DB Roberts, will be attending AmCon Advanced Design & Manufacturing Expo March 19-20, 2019 at the Greater Tacoma Convention Center, Tacoma, WA. Come visit us in Booth #322/324 to see why UL94V-0 Rated and FAA Approved Spring-Fast® Grommet...
read moreInvitation to JSWAG Highlights Importance of EWIS Wire Protection
The importance of wiring is well known to the military. It does no good to have state of the art - and expensive - avionics, if the wiring system cannot supply it with the data it needs. A “simple” wire issue can make a multimillion dollar system function poorly or...
read moreDTi Wire & Equipment Protection Making Inroads into US & EU Rail Transit Market
The rail and transit market is growing, and that is driving demand for diesel-electric locomotives, heavy and light-rail cars, rapid transit cars, rolling stock, control systems, and communications. North America has long been the leading player in freight while...
read more